The Lensiora holder can be used to safely store the camera when not in use on a wall or on the side of the monitor.
The holder is equipped with a sensor which will turn the camera ON when removed and OFF when camera is placed back into the holder.
Mount using Screws
Select a space on drywall or wood away from the high traffic areas. Make sure it is placed high enough to allow space for the cable to rest without being bent.
Start by aligning the holder vertically with the wider slanted opening pointing upward and using a Philips screwdriver, drive in the two screws starting with the top one.
Mount using 3M Command double-sided tape
Select a space on a vertical surface away from the high traffic areas. Make sure it is placed high enough to allow space for the cable to rest without being bent.
HINT: A great space to place the camera holder is the side of the monitor.
Peel off the RED protective paper from the 3M Command tape and apply it to the holder. Press it for 30 seconds.
Peel off the BLACK paper (wall side) and start by aligning the holder vertically with the wider slanted opening pointing upward.
Press the holder onto the surface and hold it under pressure for 30 seconds.
To remove the holder, pull up gently on the flexible 3M Command tab. To reapply, you may need to use a new 3M Command tape (Medium size).
